Published at Monday, November 19th 2018. by Felecia Stephenson in Ceiling Light.
Lighting box on the ceiling then cut the metallic studs to the dimensions required for the box. Here, I'm using a tool called a nibbler. It is easy to use and makes precise cuts now drill into the studs to create holes for the fixing screws. The fixing screws slightly protrude out of the stack. This will allow you to mark the areas you need to drill into the ceiling to avoid airborne dust. Here's a useful tip, simply tape a small piece of plastic right over the point you wish to drill into the dust will gather inside the plastic, insert a plug in each hole and screw the metallic studs onto the ceiling. Each stud is secured onto the ceiling using two screws one on each end.
This is the result once the four studs have been installed. Next insert a small cube block inside one of the studs join together, a small cube block with a large block. The three blocks are then assembled together effectively linking the two studs. This is repeated at each angle. The key nuke blocks slide into the studs and allow you to adjust your structure perfectly here is the result now add on the remaining elements of the metallic structure place. A small cube block onto the existing structure and another one inside the metallic stud putting the blocks together will easily put the stud into place repeat this for each side, the metallic structure is now complete.
Next cut out the side panels of your lighting box from plasterboard, the trick is to carve out along the cutting line with a knife. Flip the plasterboard around and with a hard tug break off. Your panel cut the remaining cardboard a few quick strokes of the plasterboard cleaner will smooth out the edges, apply compound along the edges of the panel and fix it onto your metallic structure, remove any excess compound or the thin spatula repeat this for each side. It is now time to work on the horizontal panel of your laminates drilling the holes for the screws and those four, the spotlights.
In this example, I am planning to install LED along the fringes of the box, for a beautiful lighting finish to conceal the LEDs, I'm using thin slats of wood, which will be glued and nailed along. The edges of the box apply two or more coats of paint on the horizontal panel of the box, sand down, use finishing compound and apply one or two coats of paint to ensure perfect positioning of the panel.
Any content, trademark’s, or other material that might be found on the somnathmahadev.com website that is not somnathmahadev.com’s property remains the copyright of its respective owner/s. In no way does somnathmahadev.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 somnathmahadev.com. All Rights Reserved.