Published at Monday, November 19th 2018. by Doreen Hahn in Ceiling Light.
You will start by installing the ceiling bracket thread the wires through the center of the ceiling bracket, press it flushes against the ceiling and installs it using the screws and washers provided. Next, you will be attaching the grommets to the blades. Now is a good time to get a friend to help you install the grommets. Next, you will be hanging and wiring the motor, while holding the wires out of the way, lift the motor assembly and place the square hanger into the opening in the ceiling bracket.
Once the motor is in place, use the two locking screws to secure the motor to the ceiling bracket connect the appropriate wires using the wire connectors provided after your wires are connected gently push them back into the ceiling bracket. Next, you will be installing your motor housing you'll notice. There is a raised dimple on each side of the motor housing. This will assist you in the installation of this piece, raise the motor housing up and over the motor and the ceiling bracket use the hardware provided to install the four motor housing screws and tighten them with a screwdriver next you'll be assembling the blades choose, which side Of the blade you'd like to have facing down line up the blade, with the blade iron and install using the blade iron screws lightly attached, the blade irons to the motor with the screws provided then securely tightened after both screws are attached.
Next, we will be installing the switch housing pre-installed to housing assembly screws halfway into the bottom of the motor feed. The wire plug through the center hole of the upper switch housing cap then wrap the keyhole slots around the screws and twist counterclockwise then insert the third screw and securely tighten all three screws. Next, you will be assembling the light kit free, install two of the switch housing screws into the side of the upper switch housing cap.
Next connect the plugs from the upper and lower switch housing, make sure to line up the color markings on the connectors, lift the lower switch housing and twist it clockwise into place and secure it by tightening all three screws once you've installed, the switch housing be sure To install your light bulb before moving on to the next step, now we are going to install the glass bowl loosen the thumb screws insert the bowl into the fixture and retighten the thumbscrews securely, be careful not to over-tighten, then connect the appropriate light and fan Pendants, congratulations. You've installed your hunter. A low-profile ceiling fan, use the pull chains to adjust your light and fan speeds,
Any content, trademark’s, or other material that might be found on the somnathmahadev.com website that is not somnathmahadev.com’s property remains the copyright of its respective owner/s. In no way does somnathmahadev.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 somnathmahadev.com. All Rights Reserved.