Published at Thursday, 08 November 2018. Ceiling Light. By Lupe Sampson.
You have your neutral ground and a hot wire and comes with an installation guide and also some screws. So the first thing you want to do is remove the diffuse here and have an assistant hold the metal part on the side. Here then turn this counterclockwise and then this will come off, and then you see the holes for mounting this and also the array of surface mount LED. That's here. I just want to point out that you see the two holes right here. These are actually wider than what I have on the outlet.
So I'm ready to take this out and then put in the LED one. The next thing is to loosen the two screws right in the middle here on this light fixture, all you have to do is loosen it after you loosen the screws just give a little twist and they'll come out, go ahead and disconnect these wires and, of course, Make sure your breaker is off, so you don't get electrocuted, so I've been blocked the light fixture. The nickel finish is metal here, and this diffuse is glass on the back side.
So what you need to do, if you run into this, is to remove this screw, is holding the LED driver and then release the clip. And then you see two additional mounting points here, and these two other mounting points are more narrow than these two right here. So go ahead and line up the screws you have and then tighten up the screw after you tighten the screws and go ahead and push these wires back up in the hole and then click the LED driver back in and reinstall the Phillips screw.
Any content, trademark’s, or other material that might be found on the somnathmahadev.com website that is not somnathmahadev.com’s property remains the copyright of its respective owner/s. In no way does somnathmahadev.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 somnathmahadev.com. All Rights Reserved.