Published at Thursday, 08 November 2018. Ceiling Light. By Felecia Stephenson.
Installation for a light kit, you start by removing the cap on the bottom of the fan. There are three screws, so you have your cap. You'll need this cap to put onto your light kit. In this part, we're removing the center cap to reveal the thread, use a screwdriver or anything just push it out and take it out and disregard this piece. Then you take your light kit, remember more spices and your cap to your kit. It just goes over and screws into place. Tighten it down. The cap is now on your kit. Once you have the cap on, you have 15 screws.
The blue and the black together make sure your wire nuts are down tight and you have your light kit wired next you're, going to put your three screws back in to hold your Lycan into place, just tuck your wires. There's a notch on the cap. It lines up with the forward: reverse switch on the fan, so it goes into place and your holes line up, and you put your screws back in now that you're like it's in place, we've already put our screws on just loosely.
You need to put on to hold the glass. It's a good time to do that now before you put it onto the fan, so put them just put them loosely on in this next step. We're going to attach the black kit with our screws, and our cap on you, find your white and blue wire will be jacketed with the safety and also calls out that it's a light kit wire. Once you have your white and your white wire together, you put your blue wire and your black wire together. This is the hot lead for the light kit and then we'll assemble.
Any content, trademark’s, or other material that might be found on the somnathmahadev.com website that is not somnathmahadev.com’s property remains the copyright of its respective owner/s. In no way does somnathmahadev.com claim ownership or responsibility for such items, and you should seek legal consent for any use of such materials from its owner.
Copyright © 2018 somnathmahadev.com. All Rights Reserved.